TL;DR
- Electric storage can work for a large family — but only if the tank is sized correctly and the system is set up on an off-peak tariff.
- A 315L tank is the minimum worth considering for 5 or more people. Smaller tanks will run out before the next heating window.
- The biggest risk isn’t the system — it’s the recovery time. Electric storage heats slowly, so back-to-back showers at peak times can drain the tank before it catches up.
- If your household runs hot water hard across multiple bathrooms in the morning, electric storage may not be the best fit. Gas continuous flow or a heat pump are worth comparing.
- If you’re on solar or a controlled load tariff, electric storage becomes a much stronger option for a big household.
The honest answer: it depends on three things
Electric storage is the most common hot water system type in Australian homes, and it’s easy to see why. It’s the cheapest to buy and install, it’s reliable, and it works. But for a large family — say, five or more people across multiple bathrooms — the system has to be set up correctly or it’ll let you down at the worst possible time.
The three things that decide whether electric storage works for a big household are: tank size, tariff setup, and how your household actually uses hot water. Get all three right, and it can absolutely do the job. Get one wrong, and you’ll be the last one into a cold shower.
Tank size: where most people get it wrong
The most common mistake with electric storage in a large home is undersizing the tank. A 250L system that works fine for a family of four starts to struggle once you add a fifth or sixth person — especially if there are multiple bathrooms running in the same morning window.
As a general guide for electric storage:
- 1–2 people: 125–160L
- 3–4 people: 160–250L
- 5–6 people: 250–315L
- 7+ people or multiple bathrooms: 315L or larger, sometimes a designed solution
For a large family home, a 315L tank is the realistic starting point. Some households with high demand — teenagers taking long showers, a double-bathroom morning routine, a household that fills the bath regularly — will find even 315L tight on an off-peak setup. A 400L unit exists for exactly these situations.
The tank size question is also connected to the element type. Single-element tanks heat more slowly than twin-element units. For a big household on off-peak power, a twin-element 315L system gives you more recovery capacity if you need a top-up outside the overnight window.
The off-peak tariff: the setup that makes electric storage work for families
Electric storage has a reputation for high running costs — and on a standard peak tariff, that reputation is earned. But most Sydney homes with electric storage are (or should be) on a controlled load tariff, which changes the picture significantly.
In NSW, the controlled load circuit — sometimes called Controlled Load 1 or CL1 — schedules your hot water system to heat during an overnight window, typically somewhere between 10pm and 7am. The electricity rate during this window is substantially cheaper than peak daytime rates.
For a large household, the logic is straightforward: the tank heats overnight, and the stored hot water covers the family’s morning demand. If the tank is sized correctly, there should be enough hot water to get everyone through the morning without running out before the next heating window kicks in.
The catch is that if your household drains the tank before the next off-peak window, there’s no automatic top-up at the cheaper rate. You either wait, or you use the boost switch on the switchboard — which draws power at peak rates.
Controlled Load 2 (CL2) offers longer daily windows and can provide daytime top-ups, which suits households with unpredictable usage patterns. It’s worth asking about when you’re setting up or replacing a system.
Recovery time: the part that catches large families out
Recovery rate is how long the system takes to reheat after hot water has been drawn from the tank. This is where electric storage has a genuine limitation compared to gas.
Electric storage typically recovers in 45 to 120 minutes after heavy use. Gas storage heats in roughly half that time. A continuous flow gas system has no recovery time at all — it heats on demand, so it never runs out.
For a large family with staggered showers, electric storage can manage. But if your household has three or four people showering back to back in the same morning window, and the tank is already partially depleted from the evening before, you may hit the bottom of the tank before the last person is done.
This isn’t a reason to rule out electric storage — it’s a reason to size up the tank and think about your household’s actual usage pattern before committing.
When electric storage works well for a large household
Electric storage is a strong choice for a large family if one or more of the following applies:
- You have solar panels. An electric storage tank is one of the best ways to use daytime solar generation. You can time the system to heat during peak solar output hours rather than overnight, effectively getting hot water for close to nothing.
- You’re on a controlled load tariff. The overnight heating window keeps running costs manageable, especially with a well-insulated 315L tank.
- Your household’s hot water use is spread through the day. If showers and baths are staggered rather than all happening in a 45-minute morning window, the tank has time to partially recover between uses.
- You want the lowest upfront cost. Electric storage is the cheapest system to buy and install. For a large tank, you’re looking at a different price range than a small unit, but it’s still well below the cost of a heat pump or solar hot water system.
- There’s no gas connection at the property. If the house isn’t connected to natural gas, electric storage or a heat pump are the practical options.
When electric storage struggles in a large home
There are situations where electric storage isn’t the right call, even if the tank is correctly sized:
- Multiple bathrooms running simultaneously. If two or three showers are running at the same time — common in a large family home on a school morning — electric storage can’t keep up the way a continuous flow gas system can.
- High peak-time usage with no solar. If the household uses most of its hot water during peak electricity hours and isn’t on a controlled load tariff, running costs will be high.
- A household that regularly runs out of hot water. If you’re already running out with your current system, the answer might not be a bigger electric tank — it might be a different system type entirely.
- Limited space for a large tank. A 315L or 400L tank is physically larger than most people expect. If the installation location is tight, that can limit your options.
The heat pump alternative worth knowing about
If running costs are a concern for a large household, a heat pump hot water system is worth a serious look. Heat pumps use significantly less electricity than a conventional electric storage element — they work by extracting heat from the surrounding air rather than generating it directly.
The upfront cost is higher, but NSW rebates in 2026 can bring the net price down considerably. For a large family that expects to stay in the home for several years, the running cost saving can make the investment worthwhile over time. Heat pumps also pair well with solar panels and can run on off-peak or controlled load tariffs.
The trade-off is that heat pumps recover more slowly than standard electric elements — a full recovery can take several hours. For a large household with high demand, tank sizing matters even more with a heat pump than with a conventional electric system.
If you want to understand how the two systems compare in practice, our post on instant gas vs electric hot water covers the running cost differences in detail.
A quick decision guide for large Sydney households
| Household situation | Best fit |
|---|---|
| 5–6 people, staggered showers, solar panels | Electric storage 315L, solar-optimised timing |
| 5–6 people, controlled load tariff, no solar | Electric storage 315L on CL1 or CL2 |
| 5+ people, simultaneous showers, gas connected | Gas continuous flow or gas storage |
| Large household, high running cost concern, no gas | Heat pump 315L+ (check NSW rebates) |
| Large household, currently running out of hot water | Assess system type and size before replacing like-for-like |
What to sort before you get a quote
Before calling a plumber to replace or upgrade a hot water system in a large home, it helps to know a few things upfront:
- How many people are in the household, and what does the morning hot water routine actually look like?
- Is the property on a controlled load tariff? Check the electricity bill — look for “Controlled Load 1” or “CL1” on the meter or tariff section.
- Is there a gas connection at the property?
- Are there solar panels, and if so, how much daytime generation is typical?
- What’s the available space for the tank — indoor or outdoor, and how much room is there?
A plumber who asks these questions before recommending a system is giving you a real answer. One who quotes a 250L electric tank for a six-person household without asking any of this isn’t.
If you’re not sure what’s right for your home, get in touch with the team at Jasco Plumbing. We’ll look at your setup, ask the right questions, and give you a fixed price before any work starts — no vague estimates, no surprises on the day.